Window glass repair, component 2

This week we are going to continue our series on single pane window glass repair. Let's speak about broken glass in a fixed window, usually referred to as a image window. The most typical [http://www.sawyerglass.com/ more information] sort will have metal stops on the outdoors, about all four edges of the window glass. At times these stops will be held in spot with screws, and other times there will be aluminum stops that snap in place. In some uncommon instances there will be a rubber material in place of metal. If you have the screw variety, you get rid of all of the screws and every single piece will come out. If you have the metal snap in stops, carefully pry the quit from the frame using a tiny, flat screwdriver or a putty knife. You want to commence in a corner and operate along the stop until it comes out. Do not pry also significantly since the stops can bend extremely effortlessly. If you have the rubber kind, pry a corner away using the screwdriver, grab it with your fingers, and pull out the rubber. The glass shouldn't fall out due to the fact there is a glue or tape on the edge, holding the glass in place.<br /><br />From here, You can get your measurements for the new piece of glass. The glass edges will be exposed, and you can hook your tape measure to the edge and get your width and height. If there is a hole in the glass, measure the glass thickness. If there isn't a hole, put on some gloves and carefully push on the glass where the crack is positioned. This will expose the edge so you can measure it. When you go to get the new glass, you are going to require a tube of silicone to replace the glue or tape holding the glass in place. Once you get the glass property, you require to eliminate the old glass. Go inside and reduce in between the glass and frame using a utility knife with a new blade. This will cut away the silicone or tape that is holding the old glass. Be positive to wear heavy gloves throughout this procedure to keep away from obtaining cut. Start off at the best and cut across from 1 corner to the other. Then reduce down one particular side, from leading to bottom. Do the other side the identical way. At this point the glass should fall out. You must spot a tarp or sheet below the window to catch the glass as it falls out. Making use of a stiff putty knife, scrape off the old silicone or tape from the frame. If there had been setting blocks on the bottom, be positive to reuse them. They act as shims to raise the glass off the bottom.<br /><br />Now run a bead of silicone about three/16" thick around the perimeter of the opening. Grab your new glass on the sides, angle the bottom in and the leading out, set the glass on the setting blocks, then slowly raise the glass up into place. Push just challenging enough that all four edges of the glass contact the silicone, but not so challenging that the glass makes get in touch with with the metal frame. Set up your outside stops. Never clean the glass for 24 hours so the silicone can set up.