Crafting a Thread Spool Holder Using a Dowel
De BISAWiki
(Criou página com 'Dowels are a useful instrument for woodworking initiatives. But they are functional adequate to be employed for other purposes, too. Jointly, this comparatively low-cost supply a...')
Edição posterior →
Edição de 19h39min de 12 de abril de 2014
Dowels are a useful instrument for woodworking initiatives. But they are functional adequate to be employed for other purposes, too. Jointly, this comparatively low-cost supply and your woodworking expertise can be used to make projects that increase to other hobbies. For occasion, contemplate employing a dowel to craft a thread spool holder. Straightforward accessibility to and storage for your threads is only a dowel rod and a couple of straightforward actions absent from attainable.
1. Making use of a dowel of 1/8 inch diameter and about 48 inches long, measure 3 inch lengths with a tape measure, cautiously marking every section. Contemplate far more or significantly less dowel duration based upon the measurement of the spool holder you wish to make, the number of spool holders you desire to make, or the sum of thread you have to retailer.
2. Reduce the sections making use of a noticed.
3. Use sandpaper to carefully clean the edges of every area minimize.
4. Relying on the variety of dowel pegs you want to use, approximate and protected the dimensions of the wooden that you will use as the holder's base. Bear in mind that it is very best to enable at least two inches between dowel pegs to accommodate various thread spool dimensions, as well as to allow for a thickness that will accommodate the 3 inch dowel pegs, as they will be inserted into the foundation later on in the project.
5. Prepare the wood for drilling by marking it where the dowel pegs will be inserted. Leave a one particular inch margin among the outer edges of the wood and the 1st mark of each and every row. Then, proceed by marking the wooden in two inch increments, aspect to side and entrance to again.
6. Employing a 1/8 inch bit, drill a depth of about 3/4 inch into every mark manufactured into the wood.
7. Drop some wooden glue into every drilled gap.
8. Insert a solitary wooden dowel peg into every hole, and permit some time for the glue to dry.
9. If you so want, paint the thread spool holder to include color to it, or to complement a stitching or crafting place or room. If you decide on to paint the thread spool holder, allow enough time for drying before inserting spools of thread on the dowel pegs.
With a little creativeness, the flexibility of a quality hardwood dowel extends over and above the norm of woodworking projects and can be creatively used to simplify and organize inside other hobbies as well.
