Trouble Shooting Residential Tanning Beds

De BISAWiki

A residential tanning bed is typically purchased by people who want to have a tan with out bothering to dress up and go to a tanning salon. A tanning bed at property tends to make it much more practical for a individual to get that wonderful tan. But a residential tanning bed also means added duty for the owner. Technologies is never ideal, like the humans who use them. Therefore, the house tanning bed may possibly be subject to many problems. Fortunately, the owner of such tanning bed need not contact a technician every time some thing goes wrong with it. Right here is a guide that will be beneficial for the owner of a residential tanning bed.

If the bed refuses to commence or to turn on, there could be 4 attainable factors:

1. There is no energy supplied to the bed

two. There is a negative relay

3. Get further on our favorite partner URL by navigating to Jump Starters Or Jumper Cables?. There is a loose at the relay

four. There is a loose wire at the dial timer

The owner should inspect the plug and the breaker to make sure that there is energy going to the bed. If the relay is poor, then there is no other way to fix the bed but to replace the relay. As for loose wires, all the owner has to do is to tighten the loose connection.

If the lamps dont light up, there are five feasible causes:

1. Malfunctioning lamps

2. Malfunctioning ballast

three. Malfunctioning lamp holder

4. Malfunctioning starter

five. A loose wire at the ballast, or at the lamp holder or at the terminal

For any malfunctioning part of the tanning bed, the owner will require to replace it. The owner should not try to fix it by himself. For the loose wire, the owner may possibly just tighten the loose connection.

If the bench lamps will not light up, the cause could be any of these:

1. The bench is not plugged into the canopy

two. A loose wire in the connector between the bench and the canopy

three. The wire in the bench-to-canopy connector could be burnt

The owner should check if the bench is securely plugged into the canopy. If not, he must correct the scenario. The loose wire required only a tightening. But if the wire is burnt, the owner have to retrieve some electrical tools so that he can strip the wire and replace the connector.

If the lamps do not work effectively but the fans are functioning fine, there are only two items to verify:

1. The relay

two. The wire either at the terminal block or the relay

The owner must verify whether or not the relay is malfunctioning or not. If it is not operating correctly, this relay ought to be replaced. Any loose wire at the terminal block or at the relay can be corrected by tightening the connection.

For other tanning bed troubles, it is best that the owner consults the technician of the tanning bed supplier.